Any recommendations on addressing frequency drift? When running WSPR on 20m my TRX shows -4 drift. A drift of -4hz is seen on first TX 2min cycle. It then takes about 4 minutes to settle back down on RX. Where is time kept? Is there a dedicated crystal or does the ATmega328P-AU keep the time?
Joshua
de KO4AWH
Frequency Drift during TX
-
- Posts: 215
- Joined: 30 Dec 2021, 21:56
Re: Frequency Drift during TX
Frequency drift is normal, especially during initial startup and heating of components. The (tr)uSDX uses crystal oscillators (please review the schematic) - these are not TCXOs.
-
- Posts: 712
- Joined: 30 Dec 2021, 19:18
- Contact:
Re: Frequency Drift during TX
As Faraaz said:
A little initial drift is normal, but it should settle.
I ran WSPR in 24hrs shifts, and there was no drift reported...
73 Manuel; DL2MAN
A little initial drift is normal, but it should settle.
I ran WSPR in 24hrs shifts, and there was no drift reported...
73 Manuel; DL2MAN
Users browsing this forum: No registered users and 28 guests