I am trying to use FT8CN with truSDX but have communication error.
I use the same FT8CN setup as with QMX, where it works great, except rig details. Here I use truSDX audio over cat) option.
Rig is already switched on and set to FT8 frequency and USB mode.
I connect the USB cable and FT8CN starts straight away
I select displayed serial port
Initially there is message that connection is successful, but then there is a message that there is communication error and connection is broken some Chinese writing and 2>1
I have turned down volume to 7 as apparently might influence things
I have 2.0x version of truSDX firmware and FT8CN v0.93
FT8CN setup CAT over USB 8n1 CI-V=A4 @ 115200
Any ideas what am I missing?
Thanks for your help
Marek
FT8CN CAT over USB cable - connection lost
-
- Posts: 71
- Joined: 03 Jan 2022, 21:11
- Location: Krakow
-
- Posts: 71
- Joined: 03 Jan 2022, 21:11
- Location: Krakow
Re: FT8CN CAT over USB cable - connection lost
Problem solved.
I switched OFF Semi QSK and all is working perfectly.
73 Marek
I switched OFF Semi QSK and all is working perfectly.
73 Marek
Users browsing this forum: No registered users and 0 guests