No output power on (tr)uSDX

[cq73@vivaldi.net]

Hi,
At first le me say that my (tr)uSDX worked perfectly after delivery. I wanted to prepare the device for digital work with just USB cable. After installing beta version of the firmware everything worked fine on RX. FT8, JS8call, Winlink. The only problem is that there is no output power. With output power prior to beta firmware installation I had no problems with TX. The battery voltage shows me 13.2V when I press the ptt. But only 0.3w of TX output. Maybe you know where the fault is? Same on SSB modulation.

[KL7MJ]

Check 3.3 TX Drive. It should be set to 4 or 5.

Mike, KL7MJ