Hello all,
I recently came into possession of a pair of uSDXes and am working on getting them working on WSJT-X via CAT control.
Image found here: https://s3-us-west-1.amazonaws.com/grou ... %2By3g8%3D
I've tried this config (both with and without Force Control Lines) and I can set the frequency easily and I can get it to go into TX mode but it won't get out of it. I have to manually hit the PTT button to break it out of TX mode. I'm using the (tr)USDx driver to get audio both in and out of the radio. The only connection between my radio is a micro USB cable. So, what do I need to change/edit to get this working the way intended?
CAT Control Troubleshooting
-
- Posts: 2
- Joined: 12 Mar 2024, 21:01
Re: CAT Control Troubleshooting
I have the same/similar problem.
I have the truSDX connected to WSJT-X (version 2.6.1) running on a mac. I am running FT8 using CAT control and the appropriate audio cables. It transmits fine and then appears to switch back into receive mode, but will not decode incoming data. If I press the PTT button as soon as it is done transmitting the truSDX receive data and everything appears to work correctly.
Not sure if this is a truSDX problem or a problem with WSJT-X, but I wish I could figure out a solution.
I have the truSDX connected to WSJT-X (version 2.6.1) running on a mac. I am running FT8 using CAT control and the appropriate audio cables. It transmits fine and then appears to switch back into receive mode, but will not decode incoming data. If I press the PTT button as soon as it is done transmitting the truSDX receive data and everything appears to work correctly.
Not sure if this is a truSDX problem or a problem with WSJT-X, but I wish I could figure out a solution.
-
- Posts: 2
- Joined: 12 Mar 2024, 21:01
Re: CAT Control Troubleshooting
Follow up on my post....
I ended up performing a factory reset on my truSDX radio and that fixed my problem. I no longer need to press PTT at the end of every transmission to get the radio to receive properly. Success!!
I ended up performing a factory reset on my truSDX radio and that fixed my problem. I no longer need to press PTT at the end of every transmission to get the radio to receive properly. Success!!
-
- Posts: 58
- Joined: 20 Dec 2022, 20:51
Re: CAT Control Troubleshooting
Congratulations, this is good news. What Firmware version are you using?
73 Constrainted
73 Constrainted
Users browsing this forum: No registered users and 0 guests