No audio TX on SSB or FT8, OK on CW
Posted: 01 Mar 2022, 15:49
Hi All
The (tr)usdx will transmit CW OK, but not SSB or FT8.
When in SSB or FT8 the display shows T but no audio is transmitted.
I am running off 5V and using a cable for FT8 or internal mic for SSB
Voltages around audio input to the 328 are...........
PB4_MISO = 2.6V
AVCC = 4.6V
AREF = 1V
PC2_ADC2 = 0.5V
Could there be a dry joint an still show correct voltages?
I have tried the noise gate at zero, I am using the latest software and have reset the radio 3 times, the mic is fitted the correct way round all with no success.
I have a test meter but no scope
Ideas welcome
73
Mike
G0CVZ
The (tr)usdx will transmit CW OK, but not SSB or FT8.
When in SSB or FT8 the display shows T but no audio is transmitted.
I am running off 5V and using a cable for FT8 or internal mic for SSB
Voltages around audio input to the 328 are...........
PB4_MISO = 2.6V
AVCC = 4.6V
AREF = 1V
PC2_ADC2 = 0.5V
Could there be a dry joint an still show correct voltages?
I have tried the noise gate at zero, I am using the latest software and have reset the radio 3 times, the mic is fitted the correct way round all with no success.
I have a test meter but no scope
Ideas welcome
73
Mike
G0CVZ