Control settings for ATT and Noise Gate? etc.
Posted: 27 May 2022, 04:11
Trying to figure out the controls on my new (tr)uSDX.
A couple details I couldn't find in any manuals:
How should one choose an ATT (1 or 2), and determine what ATT setting works best?
Does the (tr)uSDX typically work better with the AGC on or off?
Is the Noise Gate value only used when VOX is on?
What method can be used to figure out an optimal Noise Gate setting?
Does one need to set an RIT value when operating CW, or can it be left at zero?
What's the difference in behavior between Semi QSK on or off?
What does the IQ phase control do? Should I try tweaking it if I hear opposite sideband bleed though?
I figured out how to set the Reference frequency by transmitting into a dummy load, and using another SDR receiver with an audio spectrum viewer to match the signal against WWV.
I assume a general user should not touch the Bias settings, TX drive and delay, but leave them at the factory default values. Is this correct?
Thanks and 73, Ron, N6YWU
A couple details I couldn't find in any manuals:
How should one choose an ATT (1 or 2), and determine what ATT setting works best?
Does the (tr)uSDX typically work better with the AGC on or off?
Is the Noise Gate value only used when VOX is on?
What method can be used to figure out an optimal Noise Gate setting?
Does one need to set an RIT value when operating CW, or can it be left at zero?
What's the difference in behavior between Semi QSK on or off?
What does the IQ phase control do? Should I try tweaking it if I hear opposite sideband bleed though?
I figured out how to set the Reference frequency by transmitting into a dummy load, and using another SDR receiver with an audio spectrum viewer to match the signal against WWV.
I assume a general user should not touch the Bias settings, TX drive and delay, but leave them at the factory default values. Is this correct?
Thanks and 73, Ron, N6YWU