Hello all,
My (tr)uSDX (purchased recently from aliexpress) was working fine until today. I had set it to practice mode and was doing some CW sending practice when something happened and the display got corrupted.
I tried restarting it few times, i could hear relay click but the display was not readable and was not responding to any buttons.
Attached here are some photos, any pointers to investigate this will be of real help.
Is it the heat wave
73
Gopan M0XUU
Corrupted display (SOLVED)
-
- Posts: 3
- Joined: 19 Jul 2022, 14:51
Corrupted display (SOLVED)
Last edited by m0xuu on 20 Jul 2022, 11:19, edited 1 time in total.
-
- Posts: 712
- Joined: 30 Dec 2021, 19:18
- Contact:
Re: Corrupted display
I would suggest a reset:
Press Rotary Encoder Button while powering up the radio.
Everything will be reset to factory defaults, so you need to do frequency calibration again, and if you use something else than low band RF Board, this needs to be re-entered as well.
73 Manuel; DL2MAN
Press Rotary Encoder Button while powering up the radio.
Everything will be reset to factory defaults, so you need to do frequency calibration again, and if you use something else than low band RF Board, this needs to be re-entered as well.
73 Manuel; DL2MAN
-
- Posts: 3
- Joined: 19 Jul 2022, 14:51
Re: Corrupted display
Thanks Manuel - I tried that already and the result is same. I will try to write the firmware again to see if it makes a difference.
73 Gopan M0XUU
73 Gopan M0XUU
-
- Posts: 3
- Joined: 19 Jul 2022, 14:51
Re: Corrupted display (SOLVED)
It worked ! Updated the firmware again and i got the display back. Will test further and hope no more issues.
Thanks & 73
Gopan M0XUU
Thanks & 73
Gopan M0XUU
Users browsing this forum: No registered users and 1 guest