How to change from LO version to Classic

[hellmuth]

A few days ago I received from Ali this nice (tr) usdx projekt. I have ordered it with the CLASSIC RF Board Version. So I build up all the TPs for this purpose. Today I finished all the soldering and started to test the device. I found out : with the inbuild software ( my call etc) it was possible to switch to
80m , to 60m , to 40m , to 30m and to 20m . It seems to me .... this would or must be the LO Verson.
So what to do now ? Is it nessary to renew / reprogramm the Atmel Prozessor ?
best regards , hellmuth , df7vx

[dl6sez]

Hello Hellmuth,

second question without:
sorry but simply read a little bit in the Forum here would be better
because we can simply not tell things 100 times again and again
and yes there are also Videos in DL2MAN's youtube channel...
We all do this for free Ham spirit no money at all!

No you just switch it to classical in the Menue!

73 de Chris

[hellmuth]

Thanks vy much dear Chris for your fast answer.

So I found the Band changing in the Menue under point 8.7

But in the CLASSIC- MODE I got on the DISPLAY all BANDS : 10m , 12m, 15m, 17m, 20m, 30m, 40m, 60m and 80m when I am changing the Bands by the Encoder.
Is that OK ?

In the Band configuration options I read : Classic covers only : 10m, 15m, 20m, 40m and 80m

In the HI Mode I got on the DISPLAY only: 20m, 17m, 15m, 12m and 10m .....seems to be OK.
In the LO Mode I got on the DISPLAY only : 80m , 60m, 40m, 30m and 20m ....seems also to be OK .

hellmuth , df7vx

[dl6sez]

Hello Hellmuth,

no this is normally not the case.
Did you power off wait 10s and on again?
You can also do a reset: pressing tune knob and connect to power while holding it.

73 de Chris

[hellmuth]

Chris thanks for your tip.
I push the Encoder Button and apply the 12 volt .
Next I see on the Display : RESET SETTING...an waiting for 10 or more sec.

Now I go back to Menue 8.7 and the TRX is in the LO Mode.

Changing now in the Menue 8.7 to "CLASSIC."

But the result was the same, as I wrote before,
its once again possible to select all the Bands with Encoder on the Display.
Not only the CLASSIC Bands.

[DL2MAN]

In Menu, you can switch through all Bands.
By shortcut (double-tapping the rotary encoder) it will only switch through available Bands pf selected LPF.

73 Manuel; DL2MAN

[hellmuth]

SUPER !!! Manuel many thanks , thats it. Super software.

But see my problem with the I think defect TCA9555 (port 13)

I have an PCA9555 from my Red Pitaya ....but its in bigger case and if I use that,
I must wiring all the solderpads from the small TCA9555 with small chopperwire to this bigger PCA9555
terrible solution.
best reagrds and thanks for ur help
hellmuth , df7vx