(tr)uSDX Forum

lu2efi wrote: ↑26 Feb 2023, 00:47 Hi all!
Today my truSDX stopped working, I've used it in the morning without problem and when I've tried to use it in the afternoon it doesn't boot anymore. Screen shows this string:

Code: Select all

0E0F10111213151617

and blinks every 5 seconds.

I tried to update the firmware two times: writes works fine but verification fails with "verification error; content mismatch".
Does someone have some idea to try?
Thanks in advance

That serial number with increasing numbers indicates that there is an issue with the internal memory banks of the atmega chip. He can try to install new firmware with that serial number, but I do not think there is much you can do other than replacing the chip.

DL2MAN wrote: ↑27 Feb 2023, 15:16 I´ve never seen something like this before, so I´ve asked Guido.
Here is his response:

That serial number with increasing numbers indicates that there is an issue with the internal memory banks of the atmega chip. He can try to install new firmware with that serial number, but I do not think there is much you can do other than replacing the chip.

~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~ ~
>>>: avrdude -c arduino -p m328 -P COM4 -b 115200 -U flash:w:"X:\trusdx\LU2EFI_truSDX-beta_4C304D484B4918162F_Firmware.hex":a 

avrdude.exe: AVR device initialized and ready to accept instructions

Reading | 
avrdude.exe: arduino_read_sig_bytes(): (a) protocol error, expect=0x10, resp=0x43
avrdude.exe: error reading signature data for part "ATmega328", rc=-3
avrdude.exe: error reading signature data, rc=-3
avrdude.exe: stk500_recv(): programmer is not responding

avrdude.exe done.  Thank you.